Search the Community
Showing results for tags 'remove'.
Found 3 results
I have a 95 mazda 626 automatic, I need to replace my passenger side cv axle, I banged out the locking dent and used an 18 inch breaker bar with a 32 mm socket and a cheater pipe, I put all my weight on it ( 230 lbs ) and this dam thing wont even budge. my tires are on the ground and the brake is on. I need help have no clue, Is there some sort of trick? please help. need this done asap for work.
My drivers side rear brake caliper won't slide off the pin. It was hard to pivot in order to replace the pads, after the pads were replaced, the caliper started leaking so I needed to replace it. I assume that it is rusted onto the pin at the bottom of the bracket. I sprayed some PB blaster on the pin itself where it slides into the caliper. I really need to be back on the road, I'd hate to have to go buy a caliper bracket as well. If all else fails, I'll go back to the junk yard and buy the bracket too. if any one has had any problems like this before I'd like some advice on how you got it off. Thanks.