Search the Community
Showing results for tags 'idle air adjustment'.
Found 2 results
Thanks in advance for any and all ideas! I have a 1999 626 I4 2.0L manual transmission with about 135000 miles. Recently, it was having a tough time starting, and could only start with the accelerator pedal pressed somewhat. I took it into the shop, and the mechanic found a vacuum leak, and replaced the intake manifold gasket. He mentioned that the IAC may need to be replaced too, and said it would idle a bit low until the computer readjusted. Over the next couple weeks, it drove somewhat okay but with low idle, and the engine would sometimes stall at a stop with the AC turned on. Suspecting the IAC, I bought a new cheapo replacement off of Amazon. The IAC has a metal manifold side, and a solenoid side. The manifold side is difficult to remove from the throttle housing body, so I just removed the torx screws holding the two parts together, and put the new solenoid + plunger on the old manifold. With the new solenoid on, I started the car. The engine surges to 4000 rpm for about 10 seconds and then hunts between 1200 and 1500 back and forth every couple seconds or so. I let the car run like this stationary for about 15 minutes hoping the computer would relearn the new IAC, but no luck. Here's the weird part. I put the old IAC solenoid back on, and got the same engine surge followed by idle hunting. If I unplug the IAC, the car drives mostly fine after I warm it up with some foot on the gas; otherwise it would idle around 500. I took the car back to the mechanic and he checked that there is no other vacuum leak, and reset the ECU several times, but it makes no difference. The mechanic suggested replacing the entire throttle body, but that seems like a lot of work just based on a hunch. I read that I may need to reset the ECU's IAC settings by removing the IAC connector and TPS connector, turning the car to ON for 30 seconds then OFF, then plugging the connectors back in. I tried this with no effect. Anyone have any ideas on what to try next? Thanks!
Hey all, I'd like to check the idle air adjustment screw on my 2002 626 I4. But, when I look at the throttle body, the screw in question isn't obvious. Can someone tell me where it is? Also, I do have some other problem that is causing rough idle problems, so I don't expect an adjustment of the screw to help. But, I would like to set it appropriately so that I can at least not even wonder if it has something to do with what is going on with my car. Is there a "standard" setting for that screw? Like, two turns out or something? Thanks!